If Ghost is not in the Autoexec.bat, start Ghost by typing the file name at the A:\> prompt, as follows:įor Ghost 20, type Ghostpe.exe instead of Ghost.exe. If you used Ghost Boot Wizard to create the Network Boot Disk or if you added a line for the Ghost executable file to the Autoexec.bat file on the Network Boot Disk, Ghost is already started. For further clarification, see the section "Assigning the Master and Slave computers."
Be certain which computer is the Master and which is the Slave. W ARNING: This relationship is very important if the wrong computer is set as Master or Slave, it can cause data loss on the drive you intend to copy. When restoring a disk image or a partition image, the destination drive should be the Master and the source drive should be the Slave. When creating and saving an image file or writing an image over the contents of another disk or partition, the source computer should be the Master and the destination computer should be the Slave. After you have started Ghost on each computer and selected Master or Slave, all operator input must be on the master computer. The master is the computer from which you control the connection. Determine which computer will be the master computer and which computer will be the slave.Otherwise, use a different Network Boot Disk for each computer, so that each disk uses a different IP address. If using a DHCP server, you can use the same floppy disk to run Ghost on both computers. Boot up each computer from the Network Boot Disk.To create a Network Boot Disk, click Start > Programs > Symantec Ghost or Norton Ghost > Ghost Boot Wizard.įor Symantec Ghost 8.x and 7.5, choose Network Boot Disk.įor Norton Ghost 20, choose Peer-to-Peer Network Boot Disk.To clone a disk or partition over a TCP/IP peer-to-peer connection Use the instructions in that document in place of the following steps 1, 2, and 4.
Norton ghost 2003 floppy boot disk download how to#
To start Ghost from within Windows, see the document How to start Ghost from Windows to clone between two computers. Norton Ghost 2003 has an option to start Ghost from within Windows, rather than from a bootable floppy disk. To clone a disk or partition over a TCP/IP peer-to-peer connection, first create a Network Boot Disk, and then run Ghost at each computer from the Network Boot Disk.
Note: For information on other ways to clone between two computers, see the document Using Ghost to save or write an image to a different computer. The difference is that the peer-to-peer connection uses a Master/Slave relationship, and the server uses a one-to-many relationship. Transmitting an image over a TCP/IP peer-to-peer connection is similar to using Ghost.exe with GhostCast Server or Ghost Multicast Server because both processes use a TCP/IP connection.
0 kommentar(er)
